Hi,
I have a C4500 connected to a C6500 (the connection is though two switchports TengigabitEthernet (10GBSR))
When I run "show cdp nei detail" in the C4500, I got an IP 10.1.1.1 for the C6500, but this device has not that IP address.
When I run the command in the C6500, I got the right IP address for the C4500.
The "show version" for both devices is:
-------------
-------------
For the C6500:
Cisco Internetwork Operating System Software
IOS (tm) s72033_rp Software (s72033_rp-ENTSERVICESK9_WAN-M), Version 12.2(18)SXF6, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by cisco Systems, Inc.
Compiled Mon 18-Sep-06 23:23 by tinhuang
Image text-base: 0x40101040, data-base: 0x42D90000
ROM: System Bootstrap, Version 12.2(17r)S4, RELEASE SOFTWARE (fc1)
BOOTLDR: s72033_rp Software (s72033_rp-ENTSERVICESK9_WAN-M), Version 12.2(18)SXF6, RELEASE SOFTWARE (fc1)
::::::
cisco WS-C6506-E (R7000) processor (revision 1.1) with 458720K/65536K bytes of memory.
Processor board ID SAL104897GQ
SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache
Last reset from s/w reset
SuperLAT software (copyright 1990 by Meridian Technology Corp).
X.25 software, Version 3.0.0.
Bridging software.
TN3270 Emulation software.
1 Virtual Ethernet/IEEE 802.3 interface
50 Gigabit Ethernet/IEEE 802.3 interfaces
4 Ten Gigabit Ethernet/IEEE 802.3 interfaces
1917K bytes of non-volatile configuration memory.
8192K bytes of packet buffer memory.
65536K bytes of Flash internal SIMM (Sector size 512K).
Configuration register is 0x2102
For the C4500:
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-ENTSERVICESK9-M), Version 12.2(31)SGA, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Fri 08-Sep-06 10:13 by ccai
Image text-base: 0x10000000, data-base: 0x118F6934
ROM: 12.2(31r)SGA
Pod Revision 14, Force Revision 34, Tie Revision 32
:::::
cisco WS-C4507R (MPC8540) processor (revision 11) with 524288K bytes of memory.
Processor board ID FOX103901JS
MPC8540 CPU at 800Mhz, Supervisor V-10GE
Last reset from PowerUp
3 Virtual Ethernet interfaces
100 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Configuration register is 0x2101
------------
------------
Any idea about what's the problem?
Thanks very much.
