Recover router

[gautamzone]

Dear All,

While doing a password recovery on 2691 router, i accidentally changed the config register value to 0x2162 instead of 0x2142. Now i get all junk while booting the router.

Is there a way where i can undo this mistake?

Thanks a lot

Gautam

[Kevin Dorrell]

Yes, try different baud rates on the terminal until you get the right one. If I have calculated right, 19200 should do the trick.

http://www.cisco.com/en/US/partner/docs/routers/access/2600/hardware/installation/guide/2600appC.html

Kevin Dorrell

Luxembourg

[smothuku]

Hi Gautham ,

Chnage the baud rate starting from Min. value to Max.value and check whether you are getting rommon mode at one particular value.

Thanks,

satish

[gautamzone]

Thanks a lot for your kind inputs. I will let you know.