cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
234
Views
5
Helpful
1
Replies

Remember

Hi.

Just remember.

To add the switch in VTP domain, it must be VTP Transparent and so i change to VTP Client. Correct?

Thanks

1 Reply 1

Hi,

The configuration revision number of the switch must be the lower configuration revision number of the domain. In order to make the revision number equal to zero, BEFORE you plug the switch in the network, you must set the vtp mode to transparent and then revert to client:

vtp mode transparent

vtp mode client.

I hope this helps.

Best regards.

Massimiliano.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card