Restart RSVP process

[j_poderys]

TD;DR; How one restarts RSVP process without reloading the router?

Long story:

Today in the lab network I upgraded an IOS of a router. After booting, the router established connectivity to neighbors, OSPF and LDP adjacencies, but not RSVP adjacency. After trying to bring the interface up and down with missing RSVP adjacency, I ended up restarting the router that failed to establish RSVP session. As this was a lab router - no harm done. So how one would deal with this in a live network - i.e. restart the RSVP process?

[Julio E. Moisa]

Hi

As I remember, there is no way to refresh the RSVP Signalling through a command, you can clear counters or other information but no reset the signalling, so you could remove the line under the interface and set it up again that can help.

:-)