rommon Command Line
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-10-2006 01:46 PM - edited 03-05-2019 12:44 PM
Hi I'm configuring a CatOS L3 card and I'm trying to hit the L3 management port in the L3 console port of a 4006 switch card and I'm getting an "rommon" prompt for both my l3 cards. I'm not great w/ caralyst. Any ideas on how to get to the normal router prompts? Thanks.
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-10-2006 01:58 PM
Hi ,
Please check the below link for Recovering a Catalyst 4000 Layer 3 Module (WS-X4232-L3) from a Corrupted or Missing Image, or from ROMmon Mode
http://www.cisco.com/warp/public/473/130.html.
Below link for 4006 switch recovery from rommon mode.
http://www.cisco.com/warp/customer/473/26.html#cat4k
Hope it helps you alot ..plz rate it..
Thanks,
satish
