06-08-2011 08:25 AM - edited 03-07-2019 12:42 AM
Dear All,
I just received a 1751 v router with WIC 2T installed in slot 1 and with th following vesion and flash:
[ROM: System Bootstrap, Version 12.2(1r)XE1, RELEASE SOFTWARE (fc1)
ROM: C1700 Software (C1700-BK8NO3R2SV3Y7-M), Version 12.2(8)T5, RELEASE SOFTWAR
E (fc1)
System flash directory:
File Length Name/status
1 10679668 c1700-bk8no3r2sv3y7-mz.122-8.T5.bin]
I tried to configure serial subinterface via point-to-point using the following cmd : Router(config)#int s1/0.1 point-to-point and that does not applied, (this cmd is needed for frame relay DLCI configuration) .
Should i reload another ios image? Please advice.
Thanks and regards
06-15-2011 12:31 AM
Hi Hisahm,
What encapsulation do you have in the serial interface? Do you tried to change the encapsulation under serial interface, not subinterface.
Regards,
Mauricio
06-15-2011 12:37 AM
Hi,
LIke Mauricio told you you must have the encap frame command on the physical interface before configuring a Frame-Relay subinterface because the default encapsulation for a serial is HDLC.
Regards.
Alain.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide