11-27-2020 11:50 AM
Hi ,
I had scenario what if router or switch failed to connect with internet, what are all the possible ways to connect that devices from another router and switch , is that possible?
Regards,
Vasanth R
Solved! Go to Solution.
11-27-2020 12:03 PM
You need to define failure scenarios, and is this physically can access and replace.
if not you need to design a redundancy plan, so failure can occur and automatically failover takes place..
as suggested make a small diagram and check what device fails and how to fix a quicker way.
11-27-2020 11:55 AM
You can make a redundant set up so you can minimize failures.
Always copy or backup the config daily basis out of the box (in case of any kit failure you can replace with a new kit known as good config)
Do you want more advanced, how is your exiting arrangement - make small network diagram from there start adding redundant setup.
11-27-2020 12:01 PM
Hi Balaji,
Thanks for the response, In production network what are all the possible steps for, if a switch fails to get a internet or the situation is like cant access the switch directly.
11-27-2020 12:03 PM
You need to define failure scenarios, and is this physically can access and replace.
if not you need to design a redundancy plan, so failure can occur and automatically failover takes place..
as suggested make a small diagram and check what device fails and how to fix a quicker way.
11-27-2020 12:06 PM
Sure balaji ..Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide