RSPAN need to configure on 6500, 4500

[mdzahooruddin]

I have a seniro to configure RSPAN to monitor traffic for Web Sence

source is connected to 6509 and destination is connected to 4507R

6500 is configured as backbone with VSS configuration

and 4500 is used as a server farm both are connected each other via trunk link.

[mdzahooruddin]

i have done that also configuring

i dought it might be a bug in IOS on 4500

Our problem is once we implement configuration on 4507 where server is connected, we found that our connectivity is lost.

[altheb_5]

Did you mean after configure RSPAN you can’t ping or access the server only? Or all your network have problem?

,,,,,,,,,,

[mdzahooruddin]

No, only  i can't able to reach web scene server once I implement RSPAN configuration

[Nagaraja Thanthry]

Hello,

Is the ingress VLAN you are specifying in the monitor session configuration is same as the VLAN where the WebSense device should be? Also, have you configured static MAC address table entry for the WebSense server?

Mac address-table static

Hope this helps.

Regards,

NT

[altheb_5]

In RSPAN the final destination port will be received port only , that mean you can’t access server.

So the final solution connect another  port and assign new IP for second port
That mean ,, you can take copy of traffic from port 1 (destination in RSPAN)
And you can access server from second port