03-21-2014 02:09 AM - edited 03-07-2019 06:48 PM
Hi all,
I'm trying to configure rule based span on my Nexus 7000.
I want to monitor some vlans, but limit the traffic going to my monitor station by using frame-type ipv4 filter.
The link below explains how to configure it, but my nexus doesn't recognise the command "mode extended".
Am I missing something? I'm running version 6.1.3.
Thanks,
Joris
NEXUS(config)# monitor session 1
NEXUS(config-monitor)# mode extended
^
% Invalid command at '^' marker.
NEXUS(config-monitor)# mode ?
*** No matching command found in current mode, matching in (exec) mode ***
connect Notify system on modem connection
restart Reenabling modem port
Solved! Go to Solution.
03-21-2014 02:38 AM
Hi Joris,
The rule based SPAN filtering was not introduced until NX-OS 6.2 so will not be available to you with NX-OS 6.1(3).
See the section SPAN in the NX-OS 6.2 release notes.
Regards
03-21-2014 02:38 AM
Hi Joris,
The rule based SPAN filtering was not introduced until NX-OS 6.2 so will not be available to you with NX-OS 6.1(3).
See the section SPAN in the NX-OS 6.2 release notes.
Regards
03-21-2014 02:45 AM
Thanks Steve
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: