03-22-2023 01:56 AM
On access switches 9300L we do not purchase and not installing secondary power supplies. Because of that, such switches generating fals alarms towards monitoring system. Is there any command setting or other workaround to change status of power supply from this one ("Unknown"):
#show environment power
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A PWR-C1-715WAC-P 12345678DMH OK Good Good 715
1B Unknown Unknown Disabled Bad Bad Unknown
to this one ("Not present"):
#show environment power
SW PID Serial# Status Sys Pwr PoE Pwr Watts
-- ------------------ ---------- --------------- ------- ------- -----
1A Not Present
1B PWR-C1-715WAC-P DCC54321CSTZ OK Good Good 715
Or other solution to disable reporting by switch absence of secondary power supply...
03-22-2023 02:43 AM
What firmware is the stack on?
03-22-2023 08:10 PM
-firmware is 16.12.05b
- switch is standalone, no stacking
03-22-2023 09:46 PM
Do not use 16.12.X because the entire train is buggy.
03-22-2023 03:08 AM
- FYI : https://bst.cloudapps.cisco.com/bugsearch/bug/CSCue24256 , use latest advisory release https://software.cisco.com/download/home/286322037/type/282046477/release/Bengaluru-17.6.4 , check if that can help ,
M.
03-22-2023 08:12 PM
thanks, I will check,
as I understand, firmware versions 17.x.x are for SDA-type network ?!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide