cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4999
Views
0
Helpful
9
Replies

Setting up a RDP Connection on Cisco 2514

GeeksRyan
Level 1
Level 1

Hello I'm new to the site so I apologize for any errors or for any rule breaking.  I'm very green in the world of configuring routers.  I need to set up two devices with static IP address (which I think I can do).  The big challenge I have is allowing a RDP connection to the two static IP address.  I think I need a ACL and some Nat Translation maybe.  I know it is custom to post my running config so it is attached and below:

CHAMPION>enable
Password:
CHAMPION#show run
Building configuration...

Current configuration : 1300 bytes
!
version 12.1
no service single-slot-reload-enable
service timestamps debug uptime
service timestamps log uptime
service password-encryption
!
hostname CHAMPION
!
enable secret 7 xxxxxxxxxxxxxxxxxx
enable password 7 xxxxxxxxxxxxxxxx
!
!
!
!
!
ip subnet-zero
ip name-server x.x.x.x
ip dhcp excluded-address 192.168.1.1 192.168.1.12
!
ip dhcp pool 1
   network 192.168.1.0 255.255.255.0
   default-router 192.168.1.1
   dns-server x.x.x.x x.x.x.x
!
!
!
!
interface Ethernet0
description connected to Internet
ip address x.x.x.x 255.255.255.0
ip nat outside
!
interface Ethernet1
description 192.168.1.10 security
ip address 192.168.1.1 255.255.255.0
ip nat inside
arp timeout 240
!
interface Serial0
no ip address
shutdown
!
interface Serial1
no ip address
shutdown
!
router rip
version 2
passive-interface Ethernet0
network 192.168.1.0
no auto-summary
!
ip nat inside source list 1 interface Ethernet0 overload
ip classless
ip route 0.0.0.0 0.0.0.0 x.x.x.x
ip http server
ip http port 2000
!
access-list 1 permit 192.168.1.0 0.0.0.255
snmp-server community public RO
snmp-server community communityName RW
!
line con 0
exec-timeout 0 0
password 7 13024441001F477B
login
line aux 0
line vty 0 4
password 7 06015C72475D4A48
login
!
end

1 Accepted Solution

Accepted Solutions