setting up NAT on a cisco 800 series router

[tekky1988]

Hi There,

I have a Cisco 800 series router that I need to set NAT up on. There will be four computers connecting to the internet through it. I already have the IP address coming from my cable modem I just do not know the command to get it to translate to my internal dhcp pool I have setup.

any help you can give would be appreciated.

Thanks

tekky1988

[fabios]

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtml

Hope it helps. Usually google is a good guide.

Fabio