cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
365
Views
0
Helpful
0
Replies

setup the multicast routing cross the multiple VLAN on 9300 switch

yiama
Level 1
Level 1

we have two vlan 80, and vlan 90. try to setup the video multicast from Vlan 80 to vlan 90.

The following is the topology for network.

(video source at 10.201.80.26 of Vlan 80) --->[layer 2 switch] <--trunk--> (C9300) --access port 17--> (video client at 10.201.90.5 of vlan 90)

my multicast address is 239.0.0.3:5003

~~~~~~~~~~~~~~~~~~~~~~~~~~

The following is my configuration:

#show ip igmp interface

Vlan80 is up, line protocol is up
Internet address is 10.201.80.254/24
IGMP is enabled on interface
Current IGMP host version is 2
Current IGMP router version is 2
IGMP query interval is 60 seconds
IGMP configured query interval is 60 seconds
IGMP querier timeout is 120 seconds
IGMP configured querier timeout is 120 seconds
IGMP max query response time is 10 seconds
Last member query count is 2
Last member query response interval is 1000 ms
Inbound IGMP access group is not set
IGMP activity: 3 joins, 0 leaves
Multicast routing is enabled on interface
Multicast TTL threshold is 0
Multicast designated router (DR) is 10.201.80.254 (this system)
IGMP querying router is 10.201.80.254 (this system)
Multicast groups joined by this system (number of users):
239.0.0.3(3) 224.0.1.40(1)
Vlan90 is up, line protocol is up
Internet address is 10.201.90.254/24
IGMP is enabled on interface
Current IGMP host version is 2
Current IGMP router version is 2
IGMP query interval is 60 seconds
IGMP configured query interval is 60 seconds
IGMP querier timeout is 120 seconds
IGMP configured querier timeout is 120 seconds
IGMP max query response time is 10 seconds
Last member query count is 2
Last member query response interval is 1000 ms
Inbound IGMP access group is not set
IGMP activity: 1 joins, 0 leaves
Multicast routing is enabled on interface
Multicast TTL threshold is 0
Multicast designated router (DR) is 10.201.90.254 (this system)
IGMP querying router is 10.201.90.254 (this system)
Multicast groups joined by this system (number of users):
239.0.0.3(2)

 

#show ip mroute

halo_sw1#show ip mroute
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry, E - Extranet,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report,
Z - Multicast Tunnel, z - MDT-data group sender,
Y - Joined MDT-data group, y - Sending to MDT-data group,
G - Received BGP C-Mroute, g - Sent BGP C-Mroute,
N - Received BGP Shared-Tree Prune, n - BGP C-Mroute suppressed,
Q - Received BGP S-A Route, q - Sent BGP S-A Route,
V - RD & Vector, v - Vector, p - PIM Joins on route,
x - VxLAN group, c - PFP-SA cache created entry
Outgoing interface flags: H - Hardware switched, A - Assert winner, p - PIM Join
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode

(*, 239.255.255.250), 01:08:30/00:02:34, RP 0.0.0.0, flags: DC
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
Vlan80, Forward/Sparse-Dense, 01:08:30/stopped

(*, 239.0.0.3), 01:08:33/stopped, RP 0.0.0.0, flags: DCL
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
Vlan10, Forward/Dense, 01:07:51/stopped
Vlan90, Forward/Sparse-Dense, 01:08:32/stopped
Vlan80, Forward/Sparse-Dense, 01:08:33/stopped

(10.201.80.26, 239.0.0.3), 01:01:15/00:02:04, flags: LT
Incoming interface: Vlan80, RPF nbr 0.0.0.0
Outgoing interface list:
Vlan90, Forward/Sparse-Dense, 01:01:15/stopped
Vlan10, Forward/Dense, 01:01:15/stopped

(*, 224.0.1.40), 01:08:32/00:02:32, RP 0.0.0.0, flags: DCL
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
Vlan80, Forward/Sparse-Dense, 01:08:32/stopped

 

Please help us on this multicast on the multiple VLANs

 

Thanks

0 Replies 0
Review Cisco Networking for a $25 gift card