SFE/SGE L3 functionality

rudydekeninck · ‎05-27-2010

Hello;

Is statich L3 configuration (e.g. intervlan routing) supported on a stack of SFE/SGE switches? If so, L3 failover is provided when the stack rolls over from the master to the backup master?

Also, I am wondering whether any support for VRRP (or even HSRP) is either supported or planned for a feature SW release?

Thanks a lot and best regards

Rudy

Ganesh Hariharan · ‎05-28-2010

Hello;

Is statich L3 configuration (e.g. intervlan routing) supported on a stack of SFE/SGE switches? If so, L3 failover is provided when the stack rolls over from the master to the backup master?

Also, I am wondering whether any support for VRRP (or even HSRP) is either supported or planned for a feature SW release?

Thanks a lot and best regards

Rudy

Hi Rudy,

Check out the below link for configuring intervlan routing in 3750 stacked switches,

http://www.cisco.com/warp/public/473/intervlan3750_45002.pdf

Hope to Help !!

Ganesh.H

Remember to rate the helpful post