SFP breakout command err-disable

[karlzre]

Hi, 

I'm testing the breakout command on a 10G QSFP.

When i put the part in the swith it's well recognise.

NAME: "HundredGigE1/0/7", DESCR: "QSFP 100GE SR"
PID: QSFP-100G-SL4 , VID: V01 , SN: 

but when i activate the breakout command the port become err-disable 

Hu1/0/7/1 err-disabled 1 full 100G QSFP 100G SR4
Hu1/0/7/2 err-disabled 1 full 100G QSFP 100G SR4
Hu1/0/7/3 err-disabled 1 full 100G QSFP 100G SR4
Hu1/0/7/4 err-disabled 1 full 100G QSFP 100G SR4

Hu1/0/31/1 err-disabled transceiver-incomp
Hu1/0/31/2 err-disabled transceiver-incomp
Hu1/0/31/3 err-disabled transceiver-incomp
Hu1/0/31/4 err-disabled transceiver-incomp
C9500-32C#

I'm running iosxe.17.06.03.SPA

Any idea ?

Thx

[DanielP211]

Hello!

Which device do you have? Check the tmx matrix if its supported. It seems its not.

https://tmgmatrix.cisco.com/?tpid=1564

BR

[balaji.bandi]

QSFP-100G-SL4  - as per this is QSFP

what breakout cable are you using ?

check below breakout cables :

https://www.cisco.com/c/en/us/products/collateral/interfaces-modules/transceiver-modules/datasheet-c78-736282.html

[karlzre]

Hi, 

I'm testing in a C9500-32C .

It's not a beakout cable, it's a QSFP with MPO connector which can be splitted in 4 SFP.

Interface and Hardware Components Configuration Guide, Cisco IOS XE Fuji 16.9.x (Catalyst 9500 Switches) - Configuring Interface Characteristics [Support] - Cisco

[DanielP211]

Is it an cisco original or compatible? C9500-32C is supported with original.

BR

[balaji.bandi]

I have not installed and tested that, but looking at document i do not see 32C can support that ?

or am i missing something here ?

[DanielP211]

Its shown as supported in tmx matrix.

BR

[balaji.bandi]

May switch can support that Module - but document says below models only :

[marce1000]

                            >...err-disabled transceiver-incomp
               - Check logs on the 9500 too , perhaps additional info's are provided

 M.