SG250-26 RADIUS VLAN assignment option

[Mitu81]

Hello,

I have 2 switches Cisco SG250-26 and I want to use them to authenticate wired devices using RADIUS server (NPS).

Is it possible to use these switches to automatically (dynamic) assign VLAN on ports using RADIUS ? 

Using other switches (other manufacturer) I use the current config/setup without any problem and I'm not sure if this model (SG250-26) supports dynamic VLAN assignment.

Thanks.

[balaji.bandi]

here is some guidenace :

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-250-series-smart-switches/smb3202-configure-8021x-port-authentication-setting-on-a-switch.html

[Mitu81]

Thanks for answer, I already seen this document but unfortunately is applicable only for 300 and 500 series.
Applicable Devices

• Sx300 Series

• Sx350 Series

• SG350X Series

• Sx500 Series

• Sx550X Series

I configured 802.1X and RADIUS on one SG250, when a PC is connected to one port the request is received by RADIUS server, then RADIUS sends the VLAN ID to the switch, but the switch does't modify dynamically the VLAN on that port. That's why I'm not sure if this model is capable of this.

[Vitus]

I have the same question. SG250-08,   I saw it support ieee 802.1x ， so I thought it support this authentication. But cant change vlan even the terminal authorized.