03-31-2021 11:27 AM
Hello,
we have 2 Cisco SG350x switches stacked. Firmware is v2.5.7.85.
AutoSmartport and Auto Voice VLAN is enabled.
Connecting a ip phone/desktop to the switch on unit 1 everything working. The switch detects the phone on
that port and changing Vlan Mode to Trunk with native vlan10 / tagged vlan3. (Smartport Detection Iphone+Desktop).
Desktop, which is connected on the second interface from ip phone and the ip phone getting an ip from dhcp server.
On unit2 the ports are also configured correctly, but I don't get a dhcp lease for desktop or ip phone. Manually setting ip address, both devices can't connect to any network.
Looking at the config with ssh, I can't see any diffrence on the ports on unit1 and unit2.
Any ideas ?
Thanks in advance
Dominik
03-31-2021 02:13 PM
if stack configures it should work as expected. i would advise to re-visit stack config:
Step 9. Repeat Steps 1 to 8 to configure the Member units.
03-31-2021 02:24 PM
Hello
Can you post the configuration of both switches into a file and attach to this post
04-01-2021 08:05 AM
04-19-2021 01:04 AM
Hello Paul,
did you have time to look at the configuration file ?
kind regards
Dominik
04-19-2021 04:19 AM
as per the configuration attached, i do not see any configuraiton on the ports belong to switch 2 ?
Copy any of the exiting switch1 working config to below port - connect the device and test it.
interface GigabitEthernet2/0/2 no macro auto persistent
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide