2298
Views
10
Helpful
2
Replies
show mac address-table dynamic interface FastEthernet 0/1 doesnt work
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-08-2019 04:55 PM
I would like understand example 7-5 command but this command show mac address-table dynamic interface FastEthernet 0/1 doesnt work.
Labels:
- Labels:
-
Catalyst 2000
2 Replies 2

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-08-2019 05:02 PM
PT has a limited set of commands. Try show mac address-table dynamic. In the "Ports" column you should be able to see those learned off of Fa0/1.
Also, consider learning how to use GNS3
Remember to rate helpful posts and/or mark as a solution if your issue is resolved.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2019 02:47 AM
Hi,
This is duplicate post and answer is the same. You are using PT.
Regards,
Deepak Kumar
This is duplicate post and answer is the same. You are using PT.
Regards,
Deepak Kumar
Regards,
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!
