show platform software fed switch standby etherchannel 1 group-mask

[YEH]

For the output results of the following commands
Could you please tell me what it indicates?
Also, I have port channels in a stacked configuration, and the Group Mask values for active and standby are different, can you tell me the possible cause?

show platform software fed switch active etherchannel 1 group-mask
show platform software fed switch standby etherchannel 1 group-mask

[marce1000]

 - Perhaps you could show the output results too (?)

 M.

[YEH]

@marce1000 

The following is the output result.

#show platform software fed switch active etherchannel 1 group-mask
Group Mask Info
Aggport IIF Id: 000000000000007b
Active Port: : 2

Member Ports
If Name If Id local Group Mask
-------------------------------------------------------------------
GigabitEthernet2/0/1 0000000000000099 true 3333333333333333
GigabitEthernet1/0/1 000000000000006e false bbbbbbbbbbbbbbbb

#show platform software fed switch standby etherchannel 1 group-mask

Group Mask Info
Aggport IIF Id: 000000000000007b
Active Port: : 3

Member Ports
If Name If Id local Group Mask
-------------------------------------------------------------------
GigabitEthernet1/0/1 000000000000006e true 4ec4ec4ec4ec4ec4
GigabitEthernet2/0/1 0000000000000099 false c4ec4ec4ec4ec4ec
GigabitEthernet1/0/2 000000000000006d true ec4ec4ec4ec4ec4e

[MHM Cisco World]

group-mask, 
each PO have group-mask and each port have ID that true (within group-mask) meaning this port is port member of this PO or false(out of group-mask) meaning this port is NOT member port of this PO.

[YEH]

Thank you very much.
I understood that the group mask of the port is different between Active and Standby because of the different POs they belong to.

[MHM Cisco World]

it internal SW ID, it not configurable, and Yes it different from SW to other.