09-05-2012 09:23 AM - edited 03-07-2019 08:42 AM
Hi All,
I have a problem, here are the situation
- 1 Catalyst 3750
- 1 Catalyst 2960
- 4 Finger Print
- 1 HUB
Configuration
- Catalyst 3750
Interface VLAN182
IP Address 10.62.182.254 255.255.255.0
Interface G0/2
Description Finger Print Server
Switchport mode access
Switchport access vlan182
- Catalyst 2960
Interface F0/1
Description Finger Print 1
switchport mode access
switchport access vlan182
Interface F0/2
Description Finger Print 2
switchport mode access
switchport access vlan182
Interface F0/3
Description Finger Print 3
switchport mode access
switchport access vlan182
Interface F0/4
Description Finger Print 4
switchport mode access
switchport access vlan182
Interface F0/5
switchport mode access
switchport access vlan182
Interface VLAN182
no ip address
IP default-gateway 10.62.182.254
Trunking Port
- Catalyst 3750
Interface G0/1
Switchport mode Trunk
Switchport trunk encap dot1q
- Catalyst 2960
Interface F0/24
Switchport mode trunk
Here are the problem,
If i connect Finger Print Device to port catalyst 2960, some device not sending data to server, but if i connect all Finger Print to HUB and from HUB connect to Catalyst 2960 at port F0/5, All Device(Finger Print) can send data to server...
Is there any special configuration in catalyst so all device can direct connect to port catalyst 2960 without HUB?, if so can you give me some solution to make it happen
Thanks & Regards,
Ariyanto
Solved! Go to Solution.
09-05-2012 09:32 AM
Do the servers pull an address off the network or are they hardcoded addresses ? If they are pulling an address then on all server ports add the following command , "switchport host " . See if that helps at all . Sounds like a spanning tree issue .
09-05-2012 09:32 AM
Do the servers pull an address off the network or are they hardcoded addresses ? If they are pulling an address then on all server ports add the following command , "switchport host " . See if that helps at all . Sounds like a spanning tree issue .
09-18-2012 08:59 PM
hi glen,
thanks for your info... i add with switchport host each port on catalyst whiches connected to finger print.... until now the server can receive data from finger print
09-05-2012 07:05 PM
Hi Ariyanto,
Are you able to provide show vlan and show interface trunk outputs for both switches? Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide