cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
521
Views
0
Helpful
3
Replies

Source Templates on SVI Interfaces

Felix.Schwarz
Level 1
Level 1

We want to use a source template at a SVI Interface (port channel) but this is not supported. 
Template sourcing is not supported on SVI interface.
Switch: 9200 - version 17.06.03

At the older Admin guides there is a official restrictions for interface templates but at the newer guides (f. ex. 17.5.x) the restrictions is no longer at the guide. 

Does anyone have a solution for that? 

Example what could be at this template: 
template Uplink
 switchport trunk allowed vlan 1,2,3,4,5,10
 switchport mode trunk

3 Replies 3

The config under template is for L2 not for L3 (SVI) ??

L2

why you need L2 config under SVI, that my Q.? 
SVI no need any L2 config 
it need L3 like IP address ,ACL NAT ..etc.

Review Cisco Networking for a $25 gift card