I'm trying to setup a span from two 6513 and have the folowing issue.
I have the two switch connected together with a channel-group trunk.
The span is limited to 128 ports on the 6500 so I can only use vlans as source.
I have the span traffic from each switch going into a span regenerator device than combines both source and send it out thru a single port onto my packets analyzer device.
My problem is that the traffic that enter Switch1 and goes to Switch2 is being spanned twice from each device because the channel-group trunk is part of the spanned traffic.
I couldn't find a way to exclude the trunk from the monitored traffic because I use Vlans as source instead of ports.
Any suggestion on how I can overcome this?