cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
767
Views
0
Helpful
2
Replies

Span not working on N9k -c9318

Asim Afzal
Level 1
Level 1

Hi

 

Requirement is we have configure  span and its working fine but we need to filter the traffic.scenario is

 

 

1 deny one host source  to host destination

2  try to configure vlan map and when configuring filter access group command it gives error  "acl/vlan fitler not supported for TX direction

 

How we can achieve this.snapshot of some configuration attached

2 Replies 2

Hello,

 

what is the content of the access lists ? Post the full config...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco