spanning-tree command

[FashionNStyle]

Hello

I found an article

https://www.cisco.com/c/m/en_us/techdoc/dc/reference/cli/nxos/commands/l2/spanning-tree-port-type-edge.html

It was explained how to use the commands:

spanning-tree port type edge

spanning-tree port type edge trunk

so if I understand right

spanning-tree port type edge

is used for an access port

spanning-tree port type edge trunk

is used when port is in trunking mode

but if I want to enable spanning-tree when on the other site of trunk port is a switch, hub... witch command I have to use ?

I have a firewall/router pfsense that was installed on the R320 server, should I use spanning-tree port type edge trunk ?

Thank you

[Dennis Mink]

How are you connecting those servers firewall to the switch, with multiple IP addresses/vlan or a single IP address, in which case you can make it an access port

[FashionNStyle]

Hello

This firewall is my router also I am connecting it as trunk port Uses multiple vlans

Thank you