10-30-2018 02:55 PM - edited 03-08-2019 04:30 PM
Hello
I found an article
It was explained how to use the commands:
spanning-tree port type edge
spanning-tree port type edge trunk
so if I understand right
spanning-tree port type edge
is used for an access port
spanning-tree port type edge trunk
is used when port is in trunking mode
but if I want to enable spanning-tree when on the other site of trunk port is a switch, hub... witch command I have to use ?
I have a firewall/router pfsense that was installed on the R320 server, should I use spanning-tree port type edge trunk ?
Thank you
10-30-2018 03:20 PM
How are you connecting those servers firewall to the switch, with multiple IP addresses/vlan or a single IP address, in which case you can make it an access port
11-04-2018 09:38 AM
Hello
This firewall is my router also I am connecting it as trunk port Uses multiple vlans
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide