ā12-17-2012 09:27 AM - edited ā03-07-2019 10:39 AM
Hi Everyone.
On Flat Layer 2 Network if Distribution switch has uplink to Core switch.
This Uplink port on distribution is Root Port.
Core Switch port going to Distribution switch is shown as STP FWD state.
Will it cause slowness issues to users who are connected to network on Distribution switch?
As per my undertstanding core should be STP Root for all the Vlans right?
If needed how can i make core switch port as root port ?
Thanks
MAhesh
Solved! Go to Solution.
ā12-17-2012 09:50 AM
Hi,
a root port is a designated port( so forwarding port) on a non-root bridgewhich has the lowest root path cost to the root bridge. So there is nothing abnormal here and your core should be the root bridge if you run STP between distribution and Core as you apparently do.
Regards.
Alain
Don't forget to rate helpful posts.
ā12-17-2012 09:50 AM
Hi,
a root port is a designated port( so forwarding port) on a non-root bridgewhich has the lowest root path cost to the root bridge. So there is nothing abnormal here and your core should be the root bridge if you run STP between distribution and Core as you apparently do.
Regards.
Alain
Don't forget to rate helpful posts.
ā12-17-2012 09:59 AM
Hi Alain,
Thanks for reply.
Seems i totally forgot Root Port is a port used to reach Root Bridge.
Regards
Mahesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide