Spanning Tree

[ssweehinlew]

Hi,

I would like to configure the spanning Tree the on switch A, switch B and switch C. All of them will connect to each other.

The traffic will go from switch A-> switch B -> switch C and stop it on switch C.

May I know how to find out whether there is a looping and how to test whether the spanning tree is configured successfully?

Is there any example for the configuration?

[Scott Fringer]

It would be best to move this thread to an appropriate community to afford a more timely response.

Based on your question, you might want to move this to:

Network Infrastructure>LAN, Switching and Routing

Scott

[ssweehinlew]

Thank for reminding me.

[glen.grant]

If switch C is not attached back to Switch A then there is no inherent loop in the design.  I would just make switch "A" the root for all your vlans .