06-09-2022 02:22 AM
hi all,
trying to split a qsfp port 4 ways but i get the following error
module-type qsfp-split-4 force
% bad split mode, please select 'qsfp-split-2'
thanks,
rob
06-09-2022 04:18 AM
- On which hardware model , and software version are you getting this error ?
M.
06-09-2022 04:21 AM
its a mellanox switch but uses the same syntax as cisco
06-09-2022 05:05 AM
- Yet , not a cisco device problem, consider contacting mellanox support or search for user forum with searching powers of the Net.
M.
06-09-2022 10:52 AM
I used another interface and that let me split it 4 ways
I noticed when I did a "sh int status" it was just even interfaces it was showing, so looks like for every split it uses up 2 interfaces, so the next one, I will miss the next int and slot it in the 2nd one and it works, bit wierd
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: