cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1020
Views
4
Helpful
2
Replies
Highlighted
Beginner

SRR-Queue Bandwidth Rate Limit Question

Hello

If I have an interface configured as follows (on a Cisco 3750 Switch)

Interface gi 1/0/24

Bandwidth 100000

And then added the following command

srr-queue bandwidth limit 40

Would the result be 40% of the physical 1Gbps interface or 40% of the 100Mbps Bandwidth set under the interface bandwidth command.

I have googled this to death but can't find a concrete answer.

Thanks for your help

Mark

Everyone's tags (2)
2 REPLIES 2
VIP Expert

Re: SRR-Queue Bandwidth Rate Limit Question

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Physical.

Beginner

SRR-Queue Bandwidth Rate Limit Question

Blimey

That was quick,

Thanks Joseph, much appreciated.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards