Stacking C9200-48T-E with C9200-48P-E

[Yves CHAND]

Hello everyone,

Can i stack C9200-48T-E with C9200-48P-E ?

Thanks.

[Jens Albrecht · Accepted solution]

Hello @Yves CHAND,

yes, as long as they run the same software version, same license level and mode (install/bundle).

HTH!

[M02@rt37 · Accepted solution]

Hello @Yves CHAND 

Follow bellow Cisco restrictions about c9200 stack:

• A switch stack can have up to eight stacking-capable switches connected through their StackWise ports.

• Only homogenous stacking is supported, that is, a stack of Cisco Catalyst 9200 Series Switches with only Cisco Catalyst 9200 Series Switches as stack members.

• You cannot have a switch stack containing a mix of different license levels.

• Do not stack Cisco Catalyst 9200L Series Switches with Cisco Catalyst 9200 Series Switches.

• C9200-24PB and C9200-48PB switch models can only be stacked with each other and not with other models of the Cisco Catalyst 9200 Series Switches.

• During a switchover, when the standby device syncs with the active device, the following log message is displayed on the console:

  %SM-4-BADEVENT: Event 'standby_phy_link_up' is invalid for 
  the current state 'NO_NEIGHBOR': rep_lsl_rx Gix/x/x -Traceback=

  Ignore this message. It does not have any functional or operational impact.

--

So yes, you can stack the C9200-48T-E and C9200-48P-E together.

https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-9200-series-switches/nb-06-cat9200-ser-data-sheet-cte-en.html