10-23-2018 02:32 AM - edited 03-08-2019 04:27 PM
How can i check the active vrrp for vlan788? sh standby brief doesn't show 2403:7000:A000::2/64 is v and 2403:7000:A000::1/64 as standby
Any other commands to show ipv6 standby & active?
interface Vlan788
standby version 2
standby 81 ipv6 2400:7000:A000::1/64
standby 81 timers 1 4
standby 81 preempt delay minimum 60
standby 82 ipv6 FE80::4
standby 82 ipv6 2400:7000:A000::2/64
standby 82 timers 1 4
standby 82 priority 120
standby 82 preempt delay minimum 60
ipv6 address 2400:7000:A000::3/64
no ipv6 redirects
ipv6 ospf 1 area 0
end
10-24-2018 01:52 AM
Cisco specifies thes commands to verify ipv6 HSRP operation
show standby (without brief) contains this information:
Active router is local
Standby router is FE80::20F:8FFF:FE37:3B70, priority 100 (expires in 7.856 sec)
10-24-2018 02:56 AM
Hello
@getaway51 wrote:
How can i check the active vrrp for vlan788? sh standby brief doesn't show 2403:7000:A000::2/64 is v and 2403:7000:A000::1/64 as standby
Any other commands to show ipv6 standby & active?
interface Vlan788
standby version 2
standby 81 ipv6 2400:7000:A000::1/64
standby 81 timers 1 4
standby 81 preempt delay minimum 60
standby 82 ipv6 FE80::4
standby 82 ipv6 2400:7000:A000::2/64
standby 82 timers 1 4
standby 82 priority 120
standby 82 preempt delay minimum 60
ipv6 address 2400:7000:A000::3/64
no ipv6 redirects
ipv6 ospf 1 area 0
end
You dont have vrrp enabled you have hrsp and the commands to view it would be:
show standby
show standby brief
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide