- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-10-2009 02:58 AM - edited 03-06-2019 08:32 AM
Hi ,
I need to configure Cisco 1841 to translte public IP ( 95.141.153.100) to the private IP (10.0.0.253)and vice versa.I am using ADSL2, PPPoA and Dialer interface configured for NAT overload/PAT.
Public IP 95.141.153.100 sholud be translated to 10.0.0.253 which will use to build the VPN tunnel to the remote ofice.
To build the VPN from the remote office, remote office(sonicwall) will use public IP 95.141.153.100 but when it will hit the NAT router it should get translated to Private IP 10.0.0.253/24 which is a Sonicwall LAN IP.
Can you please advise if that is possible and what configuration is needed.
Diagram:
Remote Office----->Inernet----->C1841----->Sonicwall------>LAN Switches------PC/Servers
Do I ned to create two NAT statments, one for inbound and one for out bounds traffic? ANy sample config will help.
Will SonicWall be pingable from the internet using IP 95.141.153.100 ?
Many thanks for your time and support.
Solved! Go to Solution.
- Labels:
-
Other Switching
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2009 09:30 PM
in this example We need to publish many internal services (web, smtp, ftp…) using just one public IP address (171.68.1.1)
interface Ethernet0
ip address 192.168.0.254 255.255.255.0
ip nat inside
!
interface Serial0
ip address 171.68.1.1 255.255.255.240
ip nat outside
!
access-list 1 permit 192.168.0.0 0.0.0.255
ip nat inside source list 1 interface serial0 overload
!
ip nat inside source static tcp 192.168.0.5 80 171.68.1.1 80 extendable
ip nat inside source static tcp 192.168.0.6 25 171.68.1.1 25 extendable
!
ip route 0.0.0.0 0.0.0.0 171.68.1.254

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2009 09:30 PM
in this example We need to publish many internal services (web, smtp, ftp…) using just one public IP address (171.68.1.1)
interface Ethernet0
ip address 192.168.0.254 255.255.255.0
ip nat inside
!
interface Serial0
ip address 171.68.1.1 255.255.255.240
ip nat outside
!
access-list 1 permit 192.168.0.0 0.0.0.255
ip nat inside source list 1 interface serial0 overload
!
ip nat inside source static tcp 192.168.0.5 80 171.68.1.1 80 extendable
ip nat inside source static tcp 192.168.0.6 25 171.68.1.1 25 extendable
!
ip route 0.0.0.0 0.0.0.0 171.68.1.254
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-23-2009 02:55 AM
ohassairi ,
I got the idea, thanks for the sample config.
Regards
