03-30-2009 04:27 AM - edited 03-06-2019 04:53 AM
I have a Cat6506 running CatOS with Sup720. The supervisory modules keeps on rebooting (see attachment). How can I break out of this? Thanks in advance.
03-30-2009 05:08 AM
I would call the TAC if it is happening continuosly. It's either a supervisor or memory problem and would probably have to be replaced.
03-30-2009 08:03 AM
There is no break sequence to get into ROMMON?
03-30-2009 02:52 PM
Hi David,
You can go to ROMmon but I doubt if you can do anything to fix the blade.
You need to contact Cisco TAC and get the blade RMA-ed because it has totally (and utterly) failed. Based on the following error messages:
SysAD Parity Error Exception occurred on Mar 30 2009 06:53:22
Nested exception occured
*** Mistral Interrupt on line 2 ***
IO bus interrupt due to illegal addr, no ack, etc
PC = 0xbfc12a04, Cause = 0x1000, Status Reg = 0x30419003
ROM Monitor Can Not Recover From Exception
A Board Reset Is Issued
*** Mistral Interrupt on line 2 ***
Address trap interrupt ..
PC = 0xbfc278bc, Cause = 0x80001000, Status Reg = 0x30419003
ROM Monitor Can Not Recover From Exception
A Board Reset Is Issued
Cat6k-Sup720/SP processor with 524288 Kbytes of main memory
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide