Stopping active show logging command

[ziqex]

Hi,

How can I stop active sh logging command?

I am currently using console access. Ctrl + shift + 6 + x is ignored.

Crtl + z is also ignored 

Thanks,

Daniel

[Leo Laohoo]

terminal no monitor

[ziqex]

but the logging content keep showing and you cannot leave it and go to configure terminal

[balaji.bandi]

I do not believe show Logging output you see on the console ( may be ongoing Logs on the console ?) - or corect me if i am wrong  here ?

check any debug running

loging using SSH and post show logging,

[ziqex]

I've connected to the device with console as there is problem with remote access.

I've run: sh logging 

the logs are showing and getting scrolled down but I cannot quit it

usual ctrl + z and Ctrl + shift + 6 + x is not stopping it

If i quit the serial session and reconnect it keeps showing 

I want to quit from logs being displayed due to huge buffer I don't want to wait for logs to finish displaying as it may take long time

thanks

[balaji.bandi]

what switch model  is this, if this is nexus you can do ctrl+c should exit, if Catalyst, there wont be long logs ( depends on buffer you configured).

[ziqex]

Hardware: ASA5512, 4096 MB RAM, CPU Clarkdale 2792 MHz, 1 CPU (2 cores)
ASA: 2048 MB RAM, 1 CPU (1 core)

thanks

[balaji.bandi · Accepted solution]

press "q" should quit