cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
647
Views
0
Helpful
1
Replies

Storm control problem

leeyoungsoo_2
Level 1
Level 1

Hi!

I need to config storm control to Catalyst2960s Swith to prevent broadcast traffic.

So I did a test making a self-loop but storm control was not working.

And I found that port was blocked by spanning tree. I configed "no spanning tree"command and then storm control was working.

I want to limit broadcast traffic by storm control command not spanning tree block.

Does anyone know about this problem?

Thanks in advance

1 Reply 1

amikat
Level 7
Level 7

Hi,

When Cat2960S switch experiences self-loop at a port with spanning tree configured then STP blocks the port. This is quite normal and expected behaviour which has nothing to do with the storm control. So you should choose another method of the broadcast storm control test (with spanning tree enabled).

Best regards,

Antonin

Review Cisco Networking for a $25 gift card