cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
660
Views
0
Helpful
2
Replies

STP portfast configuration

Zigmunds Vitins
Level 1
Level 1

Hi,

I have two blade system's with ESXi hosts on few servers, all ESXi servers are connected to two cisco switch in blade enclosure.

Both ESXi adapters are in active mode.

All ports on the blade switch are configured as trunk with several vlan id (same vlan id are on vSwitch's)

When I do migration from one server to another my network on virtual server stops working.

I disconnect network adapter in vm settings and connect it back - then all is fine again.

I tried change vm network to different vlan idand then back - also helps.

In vmware forum I get recommendation, that I have to enable port-fast on all my Cisco ports.

What is correct way to do it?

Thanks.

Zigmunds

1 Accepted Solution

Accepted Solutions

IAN WHITMORE
Level 4
Level 4

On the interfaces connected to server you should configure:

#spanning-tree portfast trunk

HTH,

Ian

View solution in original post

2 Replies 2

IAN WHITMORE
Level 4
Level 4

On the interfaces connected to server you should configure:

#spanning-tree portfast trunk

HTH,

Ian

Thanks.

Zigmunds