Sup II Plus support VRF?

[MARVIN SPITERI]

I have a cisco WS-X4013+    Supervisor Engine II-Plus running IOS  cat4000-i9s-mz.122-25.EWA14

is VRF-lite  supported?

according to Cisco datasheet it is not listed as per attached

then according to another technical doc. it is /..... hence my confusion ...........

Thanks,

Marvin

[vmiller]

Here is the ouptput from feature navigator.

Objective: Define a specific software image in order to view its supported features.
Select from the pull down menus to  find releases which support particular platform and feature set  combinations.View your results in the table below and repeat as  necessary to define a specific software image.
Your Selections:
All Software	Orderable Software Only
Features	Multi-VRF Support (VRF lite)
Software
Major Release
Release
Platform
Feature Set/License(s)

New Search

NOTE: The releases below may not be supported by all platforms and feature sets.

Search Results

Cisco IOS quick pick latest Releases
GD Release	12.2(53)SG4
LD Release
ED Release	12.2(25)EWA14
MD Release
Feature Set/License	Image Name	DRAM	Flash
Sort By:
BASIC L3 (RIP,ST.ROUTERS, IPX,AT)	cat4000-i9s-mz.122-25.EWA14.bin	256	32
BASIC L3 3DES (RIP,ST.ROUTERS,IPX,AT)	cat4000-i9k91s-mz.122-25.EWA14.bin	256	32

[MARVIN SPITERI]

Hi

Thanks for your feedback, yes I agree that the IOS I am using supports VRF as I tried it on a different 4500 with Sup V engine. - my question is does the HW of the Sup II plus limit this feature as two different dated datasheets do not agree on this...

As per attached VRF lite is listed as supported in datasheet published in 2004 and in another datasheet published in 2010 it is not listed....