Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Denali / Fuji / Everest
can anyone pls explain the difference ? or point me to officail cisco doc that states difference pls between new IOS-XE @Denali / Fuji / Everest ?
also I notice that for the latest Catalyst 9K series - there is no denali type ...
I have VSS running between 2 core 4510R+E switches using Sup8eI have no issues if I use copper line card ports across as VSL linkbut if I try using Cisco 10GDAC cables for VSL - it works until you physically remove one of the cables. it goes down and...
I am aware that private-vlans are not supported on edge switches like 2960 series - so my question is would it be possibel to ceate private vlans on say just the core switch which would be a 3570 or 4506 that supports private vlans and then just trun...
I have a cisco WS-X4013+ Supervisor Engine II-Plus running IOS cat4000-i9s-mz.122-25.EWA14 is VRF-lite supported?according to Cisco datasheet it is not listed as per attached then according to another technical doc. it is /..... hence my confusi...
how is the 1130 point-to-point bridge work in lighteight mode ?Is this supported on 5508 and on new 2500 series controllers?How does the WCS manage the point-to-point link?I am aware that there is Lightweight software for the 1300 series bridges but ...
Hiyes I think cisco is only giving info about ePAGP to use for MEC with VSS. But for instance my scenario is 2 x 4500-x switches with vss and distribution with a stack of 2 x 3750-x switches and I tried to research about how best to configure MEC. I ...
HI, I m using sup 7 too on 4506 E switch and have issue when I enabled ip igmp snooping querier as you say this applies to all vlans - in turn this affected badly VM machines - when I issue show mac-address table on uplinks to VM I see 'GMP' instead...
I have same issues - DHCP snooping tables working ARP inspection working - and data no issues - however on Cisco Phones - when I enable 'ip source verify' phones have problems registering - as soon as I remove this line they work perfectly - I then c...
HiThanks for your feedback, yes I agree that the IOS I am using supports VRF as I tried it on a different 4500 with Sup V engine. - my question is does the HW of the Sup II plus limit this feature as two different dated datasheets do not agree on thi...
