01-25-2022 12:12 PM
Hi,
The L3 switch from the company shows some alarms regarding supervisor engine (slot 6) being power-cycled. The module changed states from reset, disabled, RPR mode, to standy status during Sunday evening (almost 11pm) and no one was connected to the network at that time.
Although supervisor Module 6 has not been enabled as a redundancy from my site -perhaps previous engineers tried but not aware of-. Btw, IOS images from modules are not matching therefore redundancy is not working.
I wonder if this is a normal behavior from this switch, logs from the switch are being attached within a notepad file.
Thank you.
Solved! Go to Solution.
01-25-2022 12:35 PM
Hi,
If no one was connected to the device, the reason for the reload is most likely a software bug. BTW,
12.2(33)SXJ3
This version of the IOS you are running is at least 15 years old.
HTH
01-25-2022 12:35 PM
Hi,
If no one was connected to the device, the reason for the reload is most likely a software bug. BTW,
12.2(33)SXJ3
This version of the IOS you are running is at least 15 years old.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide