cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
399
Views
5
Helpful
1
Replies

switch 2 renumber does nothing

richard_artes
Level 1
Level 1

Previously I had a stack of 4 x Cisco Catalyst 2960X switches. I removed switch 1 to use somewhere else.

So I issued the command:

switch 2 renumber 1

After a reload, the switch 2 is still switch 2, and there is still no switch 1.

There is also no config for Gi1/0/x ports.

Nothing failed in the logs I can see.

Any ideas why this does not work?

There is no switch 1 in the stack.

 

 

1 Accepted Solution

Accepted Solutions

richard_artes
Level 1
Level 1

After 3 reloads this command did eventually work, now I have a switch 1.

View solution in original post

1 Reply 1

richard_artes
Level 1
Level 1

After 3 reloads this command did eventually work, now I have a switch 1.

Review Cisco Networking for a $25 gift card