02-19-2010 05:14 PM - edited 03-06-2019 09:48 AM
Trying to set a switch as the member of a cluster but I keep getting the serror "This command runs only the command switch"
cluster member 3 mac-address H.H.H
Makes no sense to me.
Anyone?
02-19-2010 05:22 PM
nelson.garcia wrote:
Trying to set a switch as the member of a cluster but I keep getting the serror "This command runs only the command switch"
cluster member 3 mac-address H.H.H
Makes no sense to me.
Anyone?
Nelson
A cluster can only have one command switch. The command you are trying to use can only be entered on the command switch and you are trying to enter it on a cluster member. To see the command switch type "sh cluster" on the memeber switch and it will tell you which switch is the command switch -
then logon on to the command switch and enter the command there.
Jon
02-19-2010 05:59 PM
Don't run the command from the member. Run the command from the master. Here's the following sequence:
1. On the switch master, run the command in enable mode: cluster enable
2. Exit out and run the command "sh cluster candidate".
3. Then go back to enable mode and enter the command "cluster member mac
Hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide