Switch Depth

[robbyde0100]

Hi All,

My company recently purchased a new manufacturing company, they have around 7 remote switch cabinets, all around 50cm deep.

Normally we buy 9300-L switches but they are too deep to fit into the cabs. 

Are there any other shallower switches that are compatible with catalyst center (DNA) or am I stuck buying new cabs?

Thanks

[balaji.bandi]

If you looking Cat 9300 Model then "am I stuck buying new cabs"  -if that cab was not deep enough

There are some IE Switches depends on requirement, they are small enough and can support DNAC as extended switches.

https://www.cisco.com/site/uk/en/products/networking/industrial-switches/index.html

[Leo Laohoo · Accepted solution]

---

@robbyde0100 wrote:
all around 50cm deep.

---

We are in the same boat.  

We are testing 9300LM and this model will fit in a 50cm depth cabinet.

[robbyde0100]

Thank you, this is great. I'm getting a quote.