07-25-2022 12:04 AM
help!! switch 2950 all light are blinking when i turn it on
07-25-2022 01:20 AM
- Possible fatal hardware problem , do you still get any output on the console ?
M.
07-27-2022 05:25 AM
i dont get any out output sir
07-25-2022 02:36 AM
This is also a case.
windows cluster (network load balanced) that was sending out multicast igmp packets.
change the mode to unicast, and switched the value for MaskSourceMAC from 1 to 0 in the registry on the windows servers that were load balanced.
07-27-2022 05:26 AM
will try that
07-25-2022 02:44 AM
If Nothing is written on the console.
Time for you to contact Cisco TAC and get the RMA
07-26-2022 04:04 AM
07-26-2022 04:23 AM
Have you connected the console cable with the switch??
Any output on the console??
07-27-2022 05:27 AM
no output sir
07-27-2022 05:48 AM
If you have support contract raise a RMA for them
07-27-2022 05:27 AM
yes
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide