Switch-Stack and Power-Stack
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-23-2023 09:39 PM
Question for the group:
We have six, 9300-48P switches that we plan on making a stack out of which is easy enough.
My question is: Can we split the power into two groups of three within the stack? (Haven't been able to find that answer in Cisco documentation. I do know you can only do four switches without going to an XPS/PowerStack Star setup.)
- Labels:
-
Other Switches
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-23-2023 10:49 PM
I think it should work , but would suggest to reach out to TAC for Confirmation
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-24-2023 01:43 AM
How many PSU you have in stack ? all have Dual PSU ?
I have not tested, but there is some possibilities, depends on how you like to split :
StackPower Partitioning Examples
some best practices :
