cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1165
Views
0
Helpful
6
Replies

switch to tftp transfer

vishalpatil86
Level 1
Level 1

Hi,

I am trying to copy startup config from access switch to mu pc where i installed tftpd

I have attached the network diagram....

When I copy startup from core switch to my pc, i am able to do it

but, when i try to copy the same from access switch to my pc, i cant

Pls help me on this. Let me know if u neeed any additional info                  

6 Replies 6

mrSS
Level 1
Level 1

is there a default gatway (192.168.10.254) on the access switch?

default gateway is 192.168.100.1 on access switch

Vishwa Mishra
Cisco Employee
Cisco Employee

Hi Vishal,

What error are you getting when you are copying image to your PC?

Do you see the tftp sever on Pc  showing any kind of error?

Also verify that you have connectivity from PC to switch (end to end ping).

Regards

Vishwa

there is no reachabilty betwn access switch and pc but i can ping pc from core switch

What are the vlan interface and its ip addresses at your core switch? You need to enaure there's reachability between the pc and the access sw before you can successfully establish tftp transfer. Lastly, check your pc's firewall, it may block incoming connection from different subnets.

Sent from Cisco Technical Support iPhone App

thanks guys...

I sorted out the issue.  i put my pc into vlan 110 and gave IP 192.168.10.25 and gateway as 192.168.100.254

thanks for the help

Review Cisco Networking for a $25 gift card