Switchport access vlan dynamic configuration on cisco switch 9200

[claude.karemera]

Hello,

please i need your assistance on how to configure Switchport access vlan dynamic  on cisco switch 9200

[marce1000]

 Ref : https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9200/software/release/16-10/configuration_guide/vlan/b_1610_vlan_9200_cg/configuring_vlan_trunks.html

 >...

Layer 2 Interface Modes

Table 1. Layer 2 Interface Modes

Mode	Function
switchport mode access	Puts the interface (access port) into permanent nontrunking mode and negotiates to convert the link into a nontrunk link. The interface becomes a nontrunk interface regardless of whether or not the neighboring interface is a trunk interface.
switchport mode dynamic auto	Makes the interface able to convert the link to a trunk link. The interface becomes a trunk interface if the neighboring interface is set to trunk or desirable mode. The default switchport mode for all Ethernet interfaces is dynamic auto .
switchport mode dynamic desirable	Makes the interface actively attempt to convert the link to a trunk link. The interface becomes a trunk interface if the neighboring interface is set to trunk , desirable , or auto mode.
switchport mode trunk	Puts the interface into permanent trunking mode and negotiates to convert the neighboring link into a trunk link. The interface becomes a trunk interface even if the neighboring interface is not a trunk interface.
switchport nonegotiate	Prevents the interface from generating DTP frames. You can use this command only when the interface switchport mode is access or trunk . You must manually configure the neighboring interface as a trunk interface to establish a trunk link.
switchport mode private-vlan	Configures the private VLAN mode.

[claude.karemera]

Hi,

Thanks, Marce.... but  I just need to know how to  Configure Dynamic Ports on VMPS Clients 

[marce1000]

 - I don't think the nexus platform can do VMPS :

            https://www.networkworld.com/article/2236203/cisco-subnet-vmps-put-a-fork-in-it.html#:~:text=VMPS%20is%20a%20Cisco%20proprietary,of%20valid%20network%20attached%20devices.

 >...

  VMPS is a Cisco proprietary solution for providing users access to a network based on their MAC address. VMPS is available on Cisco 4000/4500/5000/6000/6500 switches. As part of the configuration of VPMS a large table is constructed with MAC addresses and VLANs of valid network attached devices. 

 M.

[claude.karemera]

Hi,



It's a Catalyst 9200L cat9k_lite_iosxe.17.03.03.SPA.bin

[marce1000]

Also not in the supported list.
M.

[claude.karemera]

hi,

it's a Catalyst 9200L cat9k_lite_iosxe.17.03.03.SPA.bin