10-01-2012 08:32 PM - edited 03-07-2019 09:13 AM
Hello all,
I have been working with FreeNAS to do my TFTP service for me and it has worked great for the most part. I do config backups after every change to the server just fine and sometimes in reverse, but the other day I was going a IOS upgrade from it to the router and it gives me this error after a few minutes into the transfer:
Destination filename [c2800nm-adventerprisek9_ivs_li-mz.151-3.T.bin]?
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
%Error writing tftp://<IP_ADDRESS>/c2800nm-adventerprisek9_ivs_li-mz.151-3.T.bin (Illegal protocol operation).....
I cannot understand why it would fail at this point the server has plenty of room and has worked in the past. This error happens both in downloading and uploading IOS images. I eventually used my trusty TFTP32d and it worked, but this server should work fine.
Anyone have an idea what it is erroring on?
Thank you in advanced
Solved! Go to Solution.
10-03-2012 11:41 PM
HI Peter,
May be its due to the large files.
1. images do not support more than 16MB in size for Trivial File Transfer Protocol (TFTP).
Its better to use FTP.
here is the method about how to use:
http://www.cisco.com/en/US/ts/fn/100/fn13026.html
or
Is it possible to try the operation using ftp? See this:
Regards
Please rate if it helps.
10-01-2012 11:23 PM
Hi Peter,
I am not sure about this problem but still you can try this:
Put TFTP in ASCII mode and 2nd time switch to Binary mode.
Try with both mode.
May be it helps.
Regards
Please rate if it helps.
10-03-2012 02:13 PM
I believe I tried this correctly and these are the results:
2811-CME#cop tftp://
Destination filename [c2800nm-adventerprisek9-mz.151-4.M5.bin]?
Accessing tftp://
Loading c2800nm-adventerprisek9-mz.151-4.M5.bin from 192.168.3.205 (via BVI1): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!... [timed out]
%Error reading tftp://
2811-CME#cop tftp://
Destination filename [c2800nm-adventerprisek9-mz.151-4.M5.bin]?
Accessing tftp://
Loading c2800nm-adventerprisek9-mz.151-4.M5.bin from 192.168.3.205 (via BVI1): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!... [timed out]
%Error reading tftp://
2811-CME#cop tftp://
Destination filename [c2800nm-adventerprisek9-mz.151-4.M5.bin]?
Accessing tftp://
Loading c2800nm-adventerprisek9-mz.151-4.M5.bin from 192.168.3.205 (via BVI1): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!... [timed out]
Any new ideas?
10-03-2012 11:41 PM
HI Peter,
May be its due to the large files.
1. images do not support more than 16MB in size for Trivial File Transfer Protocol (TFTP).
Its better to use FTP.
here is the method about how to use:
http://www.cisco.com/en/US/ts/fn/100/fn13026.html
or
Is it possible to try the operation using ftp? See this:
Regards
Please rate if it helps.
10-02-2012 08:45 AM
Hi Peter,
check the most common errors here:
http://www.cisco.com/en/US/products/sw/ps2346/ps99/products_tech_note09186a0080093cdf.shtml
Hope this helps
Alessio
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide