The system is unable to boot automatically. The BOOT environment variable needs to be set to a bootable image.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2017 12:28 AM - edited 03-08-2019 10:25 AM
Hi,
When i restart the switch i am getting the error to start the switch
switch: boot
Loading "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin"...flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin: no such file or directory
Error loading "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin"
Interrupt within 5 seconds to abort boot process.
Boot process failed...
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-10-2022 01:10 AM
you have to check flash or a corrupt image creates such an issue.
try with different compatible flash and a new download image and try.
Jitendra
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-23-2024 03:58 AM
Hi, watch video and use my cisco 2960x but estimated transfer time is 7:40:21.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2022 01:49 AM
Hi Sir
What do i have to do if i have set a wrong BAUD?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-08-2022 03:56 PM
You've probably already figured this out but in case you haven't.. I think you were getting that i/o error because once you change the baud on the switch you have to immediately change it on teraterm as well. On teraterm go to setup>serial port>speed [speed]>new setting, then the copy xmodem command.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-13-2022 06:57 AM
Thanks for helping me! I figured it out after a while.

- « Previous
-
- 1
- 2
- Next »