The system is unable to boot automatically. The BOOT environment variable needs to be set to a bootable image.

[SUBBAIAH ARAVETI]

Hi, 

When i restart the switch i am getting the error to start the switch

switch: boot
Loading "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin"...flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin: no such file or directory

Error loading "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin"

Interrupt within 5 seconds to abort boot process.
Boot process failed...

[Jitendra Kumar]

you have to check flash or a corrupt image creates such an issue.

try with different compatible flash and a new download image and try.

[julien45]

Hi Sir 

What do i have to do if i have set a wrong BAUD? 

[Opreccfl76]

You've probably already figured this out but in case you haven't.. I think you were getting that i/o error because once you change the baud on the switch you have to immediately change it on teraterm as well. On teraterm go to setup>serial port>speed [speed]>new setting, then the copy xmodem command.

[julien45]

Thanks for helping me! I figured it out after a while.