cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
36794
Views
20
Helpful
18
Replies

The system is unable to boot automatically. The BOOT environment variable needs to be set to a bootable image.

SUBBAIAH ARAVETI
Beginner
Beginner

Hi, 

When i restart the switch i am getting the error to start the switch

switch: boot
Loading "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin"...flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin: no such file or directory

Error loading "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin"

Interrupt within 5 seconds to abort boot process.
Boot process failed...

18 Replies 18

you have to check flash or a corrupt image creates such an issue.

try with different compatible flash and a new download image and try.

Thanks,
Jitendra

Hi Sir 

 

What do i have to do if i have set a wrong BAUD? 

You've probably already figured this out but in case you haven't.. I think you were getting that i/o error because once you change the baud on the switch you have to immediately change it on teraterm as well. On teraterm go to setup>serial port>speed [speed]>new setting, then the copy xmodem command.

Thanks for helping me! I figured it out after a while. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers